This will become the base data for the ECU. The Accessport will reprogram the ECU with the calibration data from the map selected for installation. Maps that are not intended for the identified vehicle are displayed in gray. NOTE: In the event that the vehicle does not enter Test Mode after plugging in the green connectors, refer to the Troubleshooting Section.Īfter the Accessport identifies the vehicle, it will present a list of maps.NOTE: The Test Mode connectors must be connected whenever reflashing the ECU (Installing, Change Map Reflash, and Uninstalling).
Once test mode is verified, turn the key back to the OFF position to continue. You may hear the radiator fans cycling on/off as well as the fuel pump cycling and the 'Check Engine' light should blink. To ensure Test Mode was successfully enabled, turn the key to the ON position, but do not start the engine. With the connectors located, enable Test Mode by plugging the two connectors into each other. The Legacy and Outback models will have this located on the passenger side (see right diagram). Impreza and Forester models will have this located under the driver's side dash to the left of the steering column (see left diagram). For Subaru models utilizing an AP3-SUB-001 or AP3-SUB-002 ( Not required for AP3-SUB-003 ) Accessport, locate the green Test Mode connectors.
0 kommentar(er)
